kerbal space program xbox one how to jetison fuel

Using GameFAQs regularly with these browsers can cause temporary and even permanent IP blocks due to these additional requests. If you are using Maxthon or Brave as a browser, or have installed the Ghostery add-on, you should know that these programs send extra traffic to our servers for every page on the site that you browse.The most common causes of this issue are: I don't see this as being particularly cheaty since NASA loads some science at the very last minute while craft are on the pad.Your IP address has been temporarily blocked due to a large number of HTTP requests. You could also just put an Experiment Storage Unit under the rocket (or attached with a radial coupler) and have a ground bound Kerbal do it there. Use stock transfer system to either have your capsule Kerbal transfer to the Mk1 capsule and gather science (then return the same way or have a Kerbal who has already gathered science bring it to the Mk1 capsule and transfer it. Stage the Launch Stability Enhancers AFTER your stage 1 engines so they don't actually fire during launch.Īttach either of the extendable ladders to just below the lander can so Kerbal can climb a short distance.Īdjust root part vertically so ladder reaches ground and no farther. Place upside down heat shield under that.Īttach 4x Launch Stability Enhancers radially to the lander can NW, SW, SE, SW sides so the hatch is still accessible by a Kerbal. Stage this decoupler so it fires with stage 1. Place a decoupler on bottom under rocket engine. My intent is to be able to do this in KSP Enhanced Edition for Xbox (stock parts only), but I’m open to mods for pc, as I have ksp for both systems. PS: I do not intend on enabling the cheat menu and lowing gravity, so that I could jet pack up and down. If anyone has any suggestions, I’d love to hear them. I’ve experimented with a small vtol platform that would lower a Kerbal to the surface, and launch them back up to a makeshift boarding ramp, but this is much riskier, and equally time consuming to create. Is there a better way to take kerbin samples into orbit for study?

I’ll exit the pod, and walk down the ramp to the ground, gather a sample, walk alllllllll the way back up, jettison the ramp, and take off. Since my rocket is quite tall, this takes some considerable time and effort to both create, and use. Currently, the best method I have is to build a ramp system that connects to my command pod via a decoupler, and spirals down to the ground. I want to be able to take Kerbin surface samples into space, in order to study them in the processing lab.

Kerbal space program xbox one how to jetison fuel